Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
Carbon fibre neck bars http://www-.luthiersforum.com/forum/viewtopic.php?f=10101&t=41161 |
Page 1 of 1 |
Author: | ntredwell [ Sun Aug 18, 2013 1:29 pm ] |
Post subject: | Carbon fibre neck bars |
I'm looking for a supplier of rectangular carbon fibre bars in the UK ideally 4mm thick for a mandolin build can anyone point me in the right direction? I can get 2mm bars, would it be OK to laminate these together? Sent from my KFTT using Tapatalk 4 |
Author: | Jim Watts [ Sun Aug 18, 2013 9:08 pm ] |
Post subject: | Re: Carbon fibre neck bars |
It would be fine to laminate them together. |
Author: | Nick Royle [ Sun Aug 18, 2013 10:37 pm ] |
Post subject: | Re: Carbon fibre neck bars |
Are the ones on that auction site no good? |
Author: | ntredwell [ Mon Aug 19, 2013 1:27 am ] |
Post subject: | Re: Carbon fibre neck bars |
Jim thanks for the advice Nick haven't seen any the right sort of size on that site, do you have a link? Sent from my KFTT using Tapatalk 4 |
Author: | Nick Royle [ Mon Aug 19, 2013 2:15 pm ] |
Post subject: | Re: Carbon fibre neck bars |
My mistake, I didn't notice that you wanted rectangular ones rather than square. All the best, |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |